Pay in 4 interest-free payments of $24.94 Learn more
Ships within 48 hours · Estimated delivery Aug 11 - Aug 16
The rod end and tie rod puller with hydraulic lifting cylinder of series 129 is used for hydraulic pressing out of ball pins when removing ball joints from push and tie rods specifically for trucks and low-floor buses
Bicycle repair shops and passionate cyclists love screwdriving on a bicycle
the cylinders can be used as lifting jacks
Temperature: Precision Thermistor Response Time 10 seconds Bluetooth Range 164 ft (50m) Power Supply Rechargeable 1200mAh lithium battery / Type-C Charging Port Battery Operating Time Screen off: ＞200h
The 3-jaw pullers with adjustable reach of the Y20-11 series are used for pulling particularly large and stuck bearings
NSK UKF210-D1 Flanged Housing Unit - 50 mm ID Felt Strip The rod end and tieFlanged Housing Unit NSK flanged housing units consist of an insert bearing pre mounted in a flanged housing for bolt on shaft support against a vertical surface. Available with two , three , and four bolt flanges in cast iron, stainless steel, and thermoplastic.
US$ 29.00
US$ 16.95
US$ 27.99
US$ 25.99
US$ 22.95
US$ 29.99
US$ 28.00
US$ 24.95
US$ 25.99
US$ 54.95
US$ 27.99
US$ 45.95
